How to Install the SOL-2859 Ignition Module/Push Button Igniter Module
- Prices/Polices
- Installation Manuals
- Brochures / Literature
- Log Set Compositions
- Bromic Patio Heaters
-
Solaire Infrared Grills
Solaire Training Solaire Portable Infrared Grills Solaire 27XL Solaire 42 Solaire Side Burners Solaire Island Accessories Solaire Accessories Solaire 21 Solaire 36 Recipes Testimonials Solaire 27 Solaire 30 Solaire 56 Solaire Accent Solaire Demo Program Solaire Warranty Solaire 21XL Solaire 56T Unboxing - What's Inside Solaire "How To" Videos
- Vented Gas Logs
- Chillbuster Vent-Free Gas Logs
- Alterna (FireBalls, FireStones, FireGlitter)
- Electronic Ignition Systems
- FirePits
- Regulatory Issues
- Google SketchUp Models
- Testimonials
- Featured Articles
-
Prices/Polices
-
Installation Manuals
-
Brochures / Literature
-
Log Set Compositions
-
Bromic Patio Heaters
-
Solaire Infrared Grills
-
Vented Gas Logs
-
Chillbuster Vent-Free Gas Logs
-
Alterna (FireBalls, FireStones, FireGlitter)
-
Electronic Ignition Systems
-
FirePits
-
Regulatory Issues
-
Google SketchUp Models
-
Testimonials
-
Featured Articles
The 2859R replaces the push button in your control panel.
- Unscrew the existing push button cap to expose the plastic hex-nut which holds the existing battery holder in the control panel.
- Unscrew the hex-nut to release the battery holder.
- You will now need to gain access to the back of the control panel by removing the knobs and the four screws (one each in the upper corners, one each in the bottom corners, accessible from below the panel.
- Slide the battery holder out of the hole in the panel and remove it and the two wires which are connected to the existing Igniter Module.
- From the rear of the panel, insert the open battery holder end of the 2859R through to the front. Secure the 2859R with the hex-nut. Insert a AAA battery into the holder (+ side (bump) in, negative (flat) out). Screw on the push-button to cover the battery.
- Disconnect the three electrode wires from the existing igniter module and insert them into the back of the 2859R:
Test that you have sparking at each igniter electrode before replacing the front control panel. If not, ensure that you have a fresh battery ("new" is not always "fresh"). Ensure that the electrode wires are properly seated into the 2859R. Ensure that there are no breaks in the insulation covering the wires that would cause the electricity to arc before reaching the tips of the electrodes at the burners. If there are, you need to replace the electrode/wire assemblies:
15" (right main burner) = https://besthot.store/6100R-HV/
26" (left main burner) = https://besthot.store/6099R-HV/
72" (rotiss burner) = https://besthot.store/6102R-HV/ - Reinstall and secure the front control panel. Replace the knobs.
- Enjoy igniting your Solaire grill with the push-button rapid spark.
Featured articles
- 2024 MSRP Price List for Rasmussen Gas Logs, Alterna Contemporary Gas Fires and Chillbuster Vent-free log sets. Effective September 5, 2023
- 2024 Solaire Retail Price List, PDF and XLS format, effective March 20, 2023
- 2024-2025 Bromic Radiant Patio Heater MSRP effective July 1, 2024
- How to light the pilot on your gas log set - general instructions
- #1 Vent-Free Issue - Nuisance Shutdown (or difficulty lighting) ODS Pilot
- I can't find replacement parts for my Rasmussen Gas Log, Solaire Grill or Bromic Heater - what should I do?
- General FirePit Guidance
- Solaire Ignition Systems Replacement Parts Matrix and List
- If my infrared burner pops, what can I do?
Popular Articles
- 2024 MSRP Price List for Rasmussen Gas Logs, Alterna Contemporary Gas Fires and Chillbuster Vent-free log sets. Effective September 5, 2023
- 2024 Solaire Retail Price List, PDF and XLS format, effective March 20, 2023
- Adding Logs to a Vented Gas Log Set
- How to light the pilot on your gas log set - general instructions
- Alterna Vent-free (FireBalls, FireShapes, FireStones) Instruction Manual
- Rasmussen Vented Gas Logs Brochure
- Platinum Gas shuts down after a short time
- I want to convert my vent-free gas log from one gas type to another
- Flaming Ember Vented Burner and Double Face Addendum Instruction Manuals